ASTM D 7468:2022

1.1 The test method covers a heavy-duty diesel engine test procedure conducted under high soot conditions to evaluate oil performance with regard to valve train wear, top ring wear, sludge deposits, and oil filter plugging in an EGR environment. This test method is commonly referred to as the Cummins ISM Test. 2 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.2.1 Exception- The only exception is where there is no direct SI equivalent such as screw threads, national pipe threads/diameters, tubing sizes, or where there is a sole source of supply equipment specification. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See Annex A1 for general safety precautions. 1.4 Table of Contents: Section Scope 1 Referenced Documents 2 Terminology 3 Summary of Test Method 4 Significance and Use 5 Apparatus 6 Test Engine Configuration 6.1 Test Engine 6.1.1 Oil Heat Exchanger, Adapter Blocks, Block Off Plate 6.1.2 Oil Filter Head Modification 6.1.3 Oil Pan Modification 6.1.4 Engine Control Module (ECM) 6.1.5 Engine Position Sensor 6.1.6 Intake Manifold Temperature Sensor 6.1.7 Barometric Pressure Sensor 6.1.8 Turbocharger Controller 6.1.9 Power Supply Voltage 6.1.10 Air Compressor and Fuel Pump 6.1.11 Engine Block Preparation 6.1.12 Test Stand Configuration 6.2 Engine Mounting 6.2.1 Intake Air System 6.2.2 Aftercooler 6.2.3 Exhaust System 6.2.4 Exhaust Gas Recirculation System 6.2.5 Fuel System 6.2.6 Coolant System 6.2.7 Pressurized Oil Fill System 6.2.8 External Oil System 6.2.9 Crankcase Aspiration 6.2.10 Blowby Rate 6.2.11 System Time Responses 6.3 Oil Sample Containers 6.4 Mass Balance 6.5 Engine and Cleaning Fluids 7 Test Oil 7.1 Test Fuel 7.2 Engine Coolant 7.3 Pentane 7.4 Solvent 7.5 Preparation of Apparatus 8 Cleaning of Parts 8.1 General 8.1.1 ...

27.020, 75.100