ASTM F 1041:2026

1.1 This guide describes general procedures for squeeze-off of polyethylene gas pressure pipe and tubing as recommended in GRI-92/0147.1, GRI-92/0147.2, and OTD Project 2.14c / GTI Project 22245. Note 1: Operator squeeze-off procedures should be developed and qualified in accordance with Practice F1734 . Note 2: Pipe and squeeze tool manufacturers may be able to supply recommendations for squeeze-off with their products. 1.2 Governing codes and project specifications should be consulted. Nothing in this document should be construed as recommending practices or systems at variance with governing codes and project specifications. 1.3 This guide covers squeeze-off of polyethylene pipe and tubing manufactured in accordance with Specification D2513 . 1.4 Where applicable in this guide, "pipe" shall mean "pipe and tubing." 1.5 Units- The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered the standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

23.040.20