1.1 This specification establishes the requirements for aluminum bronze rod, bar, and shapes for copper alloy UNS Nos. C61300, C61400, C61900, C62300, C62400, C63000, C63020, C63200, C64200, and ...

1.1 This specification covers minimum requirements for agencies performing nondestructive testing (NDT). 1.2 When using this specification to assess the capability of, or to accredit NDT agencies ...

1.1 This terminology is a compilation of definitions of terms used by ASTM Committee E20 on Temperature Measurement. 1.2 Terms with definitions generally applicable to the fields of thermometry ...

1.1 This specification covers the manufacture and acceptance of reinforced precast concrete end sections for pipe, herein referred to as "end section(s)," to conform to the owner's requirements.

1.1 This specification provides the minimum specification for use of non metallic plaster bases with Portland cement based plaster. 1.2 Units- The values stated in either SI units or inch-pound ...

1.1 This specification covers reinforced concrete pipe intended to be used for the construction of pressure pipelines with low internal hydrostatic heads generally not exceeding 125 ft. 1.2 This ...

1.1 This terminology refers to the terms relating to lime and limestone products as used by the industry. 1.2 Where appropriate, the various terms defined below should be prefixed with one or ...

1.1 This test method measures the resistance to slippage of warp yarns over filling yarns, or filling yarns over warp yarns, in woven upholstery fabrics, using a specific standard seam assembly by ...

1.1 This test method determines the snagging resistance of a fabric. 1.2 Studies of fabric snagging have shown that this test method is suitable for a range of woven and knitted fabrics made from ...

1.1 This specification covers requirements and test methods for material dimensions and tolerances, hydrostatic burst strength, chemical resistance, and rapid crack resistance of polyethylene ...