1.1 This specification covers electrical contact components made from silver-molybdenum by powder metallurgical procedures. 1.2 This specification covers compositions within the silver-molybdenum ...

1.1 This specification covers electrical contact components made from silver-tungsten carbide materials by powder metallurgical processes. 1.2 This specification covers compositions within the ...

1.1 This practice specifies the general requirements for the competence to carry out sampling and analysis for air emissions tests of stationary sources. It covers testing and calibration ...

1.1 This test method provides a means for monitoring corrosivity of environmental tests that involve exposure to corrosive gases. 1.2 This test method uses a resistance monitor (RM) probe ...

1.1 This specification covers minimum requirements for twisted steel fiber (TSF) for concrete. TSF is a deformed steel wire with a non-circular cross-section that is twisted at least 360° about ...

1.1 This test method covers procedures for determining the shear resistance of a geosynthetic against soil, or a geosynthetic against another geosynthetic, under a constant rate of deformation.

1.1 This specification covers a variety of carbon, alloy, and martensitic stainless steel nuts in the size range 1/4 through 4 in. and metric M12 through M100 nominal. It also covers austenitic ...

1.1 This specification covers nominal (average) wall steel pipe piles of cylindrical shape and applies to pipe piles in which the steel cylinder acts as a permanent load-carrying member, or as a ...

1.1 This specification covers five grades of as-welded, wrought austenitic stainless steel fittings for low-pressure piping and intended for low and moderate temperatures and general corrosive ...

1.1 This specification covers stainless and alloy-steel bolting material and bolting components specially heat treated for high-temperature service, such as steam turbine, gas turbine, and similar ...