1.1 This specification covers airworthiness requirements for the design of a powered or non-powered fixed wing light sport aircraft, a "glider." 1.2 A glider for the purposes of this specification ...

1.1 This specification covers airworthiness requirements for the design of powered fixed wing light sport aircraft, an "airplane." 1.2 Units- The values given in this standard are in SI units and ...

1.1 This specification covers the requirement for installing oxygen systems in light sport aircraft. 1.2 This standard does not purport to address all of the safety concerns, if any, associated ...

1.1 This specification 2 establishes the requirements for copper conductor bar, rod, and shapes for electrical (bus) applications and rod, bar, and shapes for general applications. 1.1.1 The ...

1.1 This test method covers a procedure to determine the water-in-oil emulsification tendencies and stabilities in the laboratory. The results of this test method can provide oil behavior data for ...

1.1 This specification covers the requirements for low leaded brass rod, bar, wire, and shapes of any specified cross section produced from copper alloy UNS No. C36300, C36500, C37000, C37100, and ...

1.1 This practice evaluates a change in physical properties of firestop materials after exposure to an enhanced environmental factor. This practice does not evaluate the fire performance of the ...

1.1 This guide establishes the editorial procedures and form and style for product specifications under the jurisdiction of ASTM Committee B05 on Copper and Copper Alloys. Note 1: For standards ...

1.1 This specification addresses the airworthiness requirements related to structural durability for the design of small aeroplanes. The material was developed through open consensus of ...

1.1 This test method covers the procedure to determine the effectiveness of oil spill dispersants on various oils in the laboratory. This test method is not applicable to other chemical agents nor ...